Using Prusa MK3s Einsy board?

ZenXY Advice
1

Hi, I upgraded my MK3s to a 3.5 and this means the original Einsy controller board is no longer required. I was wondering if I could use it for a ZenXY machine build? I think there might be quite a few people out there wondering what to do with their old Einsy boards.

Thanks

Trev

2

The ZenXY needs corexy mechanism, no hot end/extruder, two motor drivers and ideally tmc quiet drivers.

So I think it should work fine. I don’t have a config for you. But I’m guessing a standard Marlin einsy config with EXTRUDERS=0 and COREXY defined is 95% there.

1 Like
3

That’s great info, thanks.