I dropped that image into a 3D model of my LR2 table, and used it to make some calculations on converting my LR2 table to an LR3 table, while still being able to fully address 4’x8’ sheets, finally realizing that I needed to widen by 1" or so (I used 25mm) my proposed LR3 gantry over what is shown in the image, and also realizing that it would require me to “fly” my belts out away from the table, using custom designed tensioner “wings” attached to my super struts. My LR2 table design and later LR3 mods are detailed on these pages:
Also, I made a video showing how I used SketchUp to combine the 2D image and my 3D model:
Also…
My custom designed tensioner wings are available on Printables here: