Started assembling on Jan 1, after getting sidetracked with a laser cutter (atomstack a5 upgraded to 10w M50 laser, love it.)
I printed parts on Ender 3 and an old Anet a8, took about 1.5 kg of pla.
I had quite a bit of hardware left over from the LR2 at the end. Quite a few ball bearings to reuse for other stuff!
Got my XZ plates from ryan. Used bitingmidge’s STRUT NUT ENCAPSULATOR.
Used Ryan’s table design but extended a bit to make a cutout for vertical clamping eventually. Glue and nailgun. Cut whole thing on table saw, 1/2" MDF.
Skinned both sides with 1/8" hardboard and nailgun, no glue. Rails are mdf boards from Lowe’s hardware. Surface will be replaceable 49X49" 3/4 Mdf. I thought it was 48x48 but measured and sure enough, 49x49.
