Hello, I am looking to build a Lowrider 3, and have printed most of the parts. I wondered if there are any publicly known details on the Lowrider 4. I am trying to decide if it’s better to pull the trigger on the hardware kit now and finish the build before I go back to school or sit on it.

TL; DR: Low Rider 4 is out and it’s great. I’m closing this post. If you have a question about the new Low Rider, I suggest making a new post (the circle with a + in it in the bottom right of the forum). I suggest choosing Advice category or the Hardware Development category. If you need this reope…

Hey @Larrybelarry , no idea how helpful this is, but I uploaded snapshot of my Cura profiles to https://github.com/aaronse/v1engineering-mods/tree/main/lowrider4/mods/3dp-profiles . Personally planning to try out Orcaslicer based on positive experience others have shared. Have been to lazy/busy to m…

I’ve never tried this method or seen it done. Are there any video examples showing how this can be accomplished?

That’s probably what I’ll do. Can anyone recommend a good laser module compatible with the SKR Pro v1.2?

Are you referring to the STL file named “temp-strut”?

Filament is brand new, both rolls Slowing down does reduce the problems but it still isn’t pretty :confused:

[image] Canadian lr3 build Your Builds Yes, like this (blue are the dowel holes): [Dowel Holes] Obviously the second program does not have the middle parts and dowel holes cut out, but the rest is identical. slight_smile Just remember to take the dowels out (or make the…

[image] Sam: referring to the STL file named “temp-strut”? The STL temp strut is printable. However, I think Aza was saying you could cut strut plates out of hardboard or MDF, but only as big as would fit on your MPCNC, and use those to strengthen the new LR4 enough to use it to cut your full…

[image] Sam: Can anyone recommend a good laser module compatible with the SKR Pro v1.2? My understanding is the Jackpot has some advantages for laser when compared to SKR, while the SKR should be fine for a LowRider. Maybe, consider switching the SKR to the LR4, and get a Jackpot for the lase…

When I get back home, I’m going to ask you to elaborate on it. How you set up your he dowel holes in the table, and in the software, etc., etc. Might as well just go ahead and make a detailed video of the whole process so I don’t have to bug you later :grin: It doesn’t sound that complicated on t…

I have to figure out how to cut mines, cause my LR3 is larger than longer😂 I had a Full Sheet machine before, but now I shortened the table to be less “invasive”… I think I’ll cut them in two times, half>rotate>half

Status on Lowrider 4

LowRider CNC Advice

Tokoloshe (Philipp) October 12, 2024, 7:19am 1099

Here is me describing the process.