Took a break from a bathroom remodel project and was able to get some simple push sticks cut out. Trying to learn FreeCAD so took these from some pictures I found online. Drew them up in FreeCAD, exported to DXF, and then did the CAM in EstlCAM. Turned out to be a nice little project for learning a bit more about FreeCAD.
Overall happy with the outcome of this. And it was nice to use some scrap of another failed cut and get something useful out of it, instead of just burning it for heat. It was cold in the shop where I am this weekend. Been in the negative numbers last couple mornings, and didn’t get much warmer over the course of the day.
