Hi All,
I am not sure if this is allowed here, but I have been making some short videos of my woodshop and posting them to social media. My LowRider 3 has been featured in some of them and I wanted to share them.
I have a 2 foot by 4 foot work area and a water cooled 2.2kw Chinese spindle running on 120v. I am connected through a Raspberry Pi running octoprint so I can send commands over wifi instead of using a wired connection. I have a relay on the spindle that turns on and off the water pump and shop vac. Super happy with the setup!
Thank you so much to the community and all your help as I was building and troubleshooting!
Dan