my left z trigger is homing fine, the right one is trying to home multiple times before it homes some times 10 or 20 times. as soon as the switch is triggered it drops. up to 10 cm some times. like the stepper is turned off looking at the forum I found this thread: [image] LR V3 …

[image] Rusty Bumblebee: is there a picture of how to do this, From the V1 SKR Docs page , [image] You want to use the resistor to jumper the red X (5V VCC) to the green dot (Signal). The switch leads from the switch still go from Signal to Ground (yellow G). Never allow Ground and 5V V…

V1E.com Forum

Right Z won't home correctly

LowRider CNC Advice

← previous page

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled