Hello all!
MPCNC, full rambo purchased from V1, Windows 7.
I just finish my first MPCNC build and have jumped into testing! Finding my first issue in no time.
Software installed on computer first. As for the Board, motors pluged in, Jumper for power added, Usb plugged in, powered up. Connected to computer.
Opened Repetier host and set the parameters like Ryan had in his basic set up in the instructions.
Com 1 had an error. Tried Auto as mentioned in other posts.
If set to Auto, error “No port available for autoselect. Please connect your printer first”
Checked device manager, yellow marker next to RAMBO, says there is not a driver.
Opened Adurino to see if it detected it, nothing.
Is there something I missed?
I think Windows 7 needs a driver.
Appreciate it Jeff, I updated the driver and it connected successfully.
1 Like