Regular end stops (not dual)

[jamiek (Jamie)]

Regular endstops work by default in the non-dual firmware. But check with M119 like Jeffe said because at a minimum you will need to check the wiring.

I used non-dual endstops for this a while ago. No special firmware tweaks were needed.

Repeatable squaring series wired MPCNC

Rebuilt in Box Frame

Finished up my repeatable squaring/positioning with series-wired motors: I used some Avery labels to print 8" long adhesive rulers and little short segments with a Vernier-style gradations (similar to belt stretch approach before) so in theory I can eyeball position to less than a mm. I also used my mirror “infinite hallway” approach to ensure that the zero position is parallel to the side rails to within one click of the motors. I think this would be very slightly better than holding again…