Hey guys,
SKR 1.4 Turbo W/ TMC2209 in UART
TFT35 3.0
I had this thing working then I tried to configure the sensorless homing and now I am lost again. I have tried to reverse my steps and go back to the old firmware to no avail. Steppers are wired in series and I have no endstops. I have re-flashed the firmware multiple times to try to correct it but it hasnt seem to have any effect. Any help is appreciated. thanks!
video of movement: https://photos.app.goo.gl/Zu4oSjsPkDMu2PV76
Just a thought. If you or your TFT made setting changes that were written to EEPROM, reinstalling the firmware does not change these settings. You might try a factory reset by sending a M502 g-code followed by a M500.
Sent M502 and M500 and it still randomly jogs when I go to the Move screen. Thank you for the suggestion though
Tried to just modify the SKR1.3 firmware for series wiring for my TMC2209 drivers but its still just doing its own thing.
configuration.h - https://pastebin.com/DxpcSMUu
configuration_adv.h - https://pastebin.com/RKSeZbJW
So I had the TFT cables switched. Maybe my mistake will help someone in the future lol.