Parts cut not symmetrical, what to do next

[Tokoloshe (Philipp)]

I rather meant that climb/conventional pushes the bit in one direction:

Climb vs. Conventional Milling...

I’ve observed climb milling produces slightly oversized parts and oversized holes, which gets worse if the feedrates are high. And conventional milling produces slightly undersized parts and undersized holes. With a finishing allowance and a finishing pass, neither is a problem but I wish Estlcam could specify climb or conventional milling on a per-toolpath basis (or per-tool would be good enough). Then I don’t have to predict the amount of deflection to set the finishing allowance.