Oak dice box

Things You've Made
1

To test my freshly build lowrider v3 i made some dice boxes for my girlfriend and one for my sister. They are made from solid white oak that i had laying around. I made the toolpaths in fusion360.
Settings:
-6mm 2 flute HSS upcut bit
-6mm doc
-1700mm/s (was pushing it at this doc in solid white oak)

I am very impressed on the performance of this machine, i didn’t go easy on it and still performed beyond my expectations! Little to no sanding was needed, only some rounding over on the router table.

IMG_9861
IMG_98613024×4032 2.47 MB

IMG_9863
IMG_98633024×4032 2.25 MB

IMG_9865
IMG_98651200×2208 379 KB

12 Likes
2

Nice. You can go pretty fast, most people rather use very conservative settings. :slightly_smiling_face:

3 Likes
3

Nice! White oak is no joke either. Great work.

4 Likes
4

I’d rather see it’s full potential :slight_smile: I get why people are conservative but I’d like to find the limits of this machine and use it as a tool. If it breaks I know that I went too far and fix it :upside_down_face: Used it again today, made a serving tray out of white oak for my grandparents. Same bit but i lowered the feed to 1200mm/s and increased the doc to 10mm, performed well.

3 Likes
5

That sounds pretty insane (and neat). Nice. :slight_smile:

2 Likes