[Not entirely] new build in Tampa

Hi Everyone! I actually got my MPCNC running a couple of months ago, but it wasn’t particularly presentable since I hadn’t done cable management on it and there were wires everywhere. I finally got around to installing the drag chains and routing cables, so here she is in all her glory!

I’ve already produced a few things from this machine. I’m still pretty new to CNCing in general, but I’m enjoying the learning process along the way. I wanted to give a huge shoutout and thanks to Ryan and the MPCNC community! The level of support, printable upgrades, etc. is nothing short of amazing!


I didn’t think the first one actually posted because I got an error. Ryan you can delete this one if you want.

Very clean build, nice job with cable management. Congrats!