No physical endstops with Archim 2?

[Loose (Louis Cannon)]

Well, then I guess I’m back to:

@Loose

I’m fairly positive it’s my lack of profile adjustment knowledge that’s slowing it down.

Forum etiquette question, if I want to ask for assistance with my Cura profile (or could it be my Octoprint profile/setup), would I continue here or start a new thread?

Going to read through his thread as it seems to have a similar situation:

Printing parts - Estimated print times wildly inaccurate

I guess I’ll start off with the printer that I’m using. It’s a Wanhao Duplicator i3 with a few upgrades (nothing that would change my stock printing speeds, just quality of prints). If you’re not familiar with this printer, it’s a very popular and very common Cartesian printer based on the Prusa i3 (also very popular and very common). So I’d expect that my print times would be somewhat close to the estimates. The only guidance I see is the infill %, which I have used on every part as specified. …