New user , missing commands/buttons

[Bartman]

@Rcj112

good link to feeds and speeds

This post explains a little bit about how to select a good feed rate and router speed based on recommended chip load for various types of end mills and materials…

Going too fast?

TLDR - I think you are using the wrong bit Caveat - I’m somewhat new to a lot of this myself, so if someone spots any mistakes, please jump in to give a better answer. Having the proper chip load is important for tool life. Too big and the load on the bit can wear out or break the bit. Too small is worse, as it will “rub” rather than cut, leading to overheating and dull the tool quickly. Here is a chart for recommended chip load ranges from Chip Load: Guide for Beginners - MellowPine The …