New MPCNC 500x700mm


I’m building a MPCNC, with printed parts in ABS and conduit, with 25mm OD and 1,9mm of wall tickness.

I like a work area about 500x700mm and Z 60mm. With this area, its possible work with aluminium, or is a large area to try aluminium?
If recommend a smaller, i will change my project. Its important to me, work with aluminium too.

I made a Google Photos Album with all photos of printed parts. I will update here the post, with the steps of the construction.

The link:

Thanks a lot for this project!!! :slight_smile:

Z is very good with 60mm for aluminum. Sides may be, but if you mill in the corner, I think you will be ok.
Barry mills aluminum with a bigger mpcnc really well.

Thanks Martin.

I will go ahead!!! :smiley: