New Build in Portland Oregon

[jeffeb3]

Take a look at this thread. Keep reading though because it was solved more than once:

Firmware uncertainties

I’ve updated from 412 to 414 and in the configuration I’m seeing Junction is now 0.1 instead of 0.01, so that should be a big help. I did a video before and after and I am still seeing sluggish behavior around arcs. I used the crown svg and Estlcam with a feed rate of 720 mm/min, aiming for the same 12 mm/sec as the official test gcode. Here is before, version 412: And after, version 414: In both cases the movement queue was not being depleted so I don’t think it’s a CPU issue. I porte…