New 36" x 36" Primo Build and some questions

[olijouve]

IMO, enclosure for laser is usefull and nice to have :

• It will help for ventilation as it will canalised/reduced the volume of air/fumes to extract.
• Also possible to make a filter panel to filter some bad lights; disclamer : Always use good laser goggles.
• You can add a webcam on top and configure it in LightBurn for visual positionning.
• You will already have your enclosure when you will decide to work with a router

If interressed have a look on mine:

My MPCNC finally found its place

Hello, I realise i haven’t share my build yet. I had a lonely week-end without wife and daugthers so i had time to build a torsion table and a first attempt for an enclosure(i think its’ ~10cm to tall), still need add front door. Table can be folded because i have to be able to park my car for holidays. I now need to find time to clean my workshop [IMG_1693] [IMG_1694] [IMG_1695]