need assistance with new Arduino board

Some background first, I own a Xcarve 1000x1000, a 2.8 w diode laser

I have recently acquired a 3060 Chinese cnc, I am rebuilding the controller for it and have purchased the following:

ramps 1.4,

full graphic LC

D and DRV8825s.

and have installed Arduino IDE on my laptop

I also have picsender for my gcode use and

Vcarve Pro to design with.

Where I need assistance is how do I go about getting all of this to work together so I can operate the 3060?

Should be plug and play, flash the firmware, make sure the steps and accelerations are correct, un-comment the correct LCD. Done.

What have you tried that isn’t working?