MPCNC Primo post processor

[Eddy_Silva]

@Steering wheel - 2 sided estlcam carving

Starting with the end result: [IMG_7840] This was my first time doing a 2 sided carve in estlcam. I made a separate job which drilled 4 concentric holes in the 4 corners of the block as estlcam thought it was. This registered the cut when I flipped it over pretty well. It was only after I started I realised my spoilboard had lifted on one side - I corrected it for the back side cut. I didn’t bother with a routing pss just a 15% finishing pass step over, 3mm DoC and 12mm/s feed. Speed 2 on the…

Sounds very good to me, I’ll try to see if I can do the same.
Thanks!