Found this thread that shows the speed settings for each half number increment of the Kobalt trim router.
Yesterday I built a table using 2x4s and 1/2” MDF. I used the scraps of the MDF as a spoil board. I’ll post pics when I get it set back up. The forecast called for rain last night, so I concentrated on the build more than the documentation side.
After considering the advice from a previous comment, I reverted to a 24”x24” build area which comes out to about 36”x36” footprint. So I built my table around 39”x39”. I built the table so it can use two foldable metal sawhorses as the legs with the tabletops’ 2x4s resting in the slots of the sawhorses. This will allow me to store the MPCNC attached to the tabletop and the “legs”(sawhorses) separately. All I should need to do for setup is level the sawhorses in line with eachother and set the tabletop on them. At least that’s my intention…