Worked through misc CANBus and Klipper setup/wiring issues. Belted, powered up and zipping around…
Intentionally leaving nozzle and PEI plate off until I understand z_tilt and mesh calibration settings better.
Still figuring out Klipper z_tilt settings and behavior. Tilt adjustment ends up making things worse, maybe I need to negate/flip direction a setting somewhere. Suggestions appreciated!
[z_tilt] #AZA doc @ https://www.klipper3d.org/Config_Reference.html?h=pixel#z_tilt
z_positions: # Pivot Points
-20,27
135, 303
292, 27
#center_Y186
points:
35, 35
135, 245
245, 35
speed: 100
horizontal_move_z: 10
retries: 10
retry_tolerance: 0.005
Technically, think I can claim a serial number as soon as it squirts hot plastic?
Edit: Chris Riley “Klipper - PID Tune - Dial In Your Printer - Chris’s Basement - 2022” helped me tune the Heater_Bed and PID based Extruder/HeaterBed temperature control settings.