I have a NIST calibrated tachometer available for medical centrifuges, and have made the below measurements on the RPM settings of the Makita RT0701C. I apologize if something similar has been posted, I searched and couldn’t find anything.
Since I only have one, I cannot guarantee that it is exactly the same for every single router, but after running calibration checks for years on centrifuges from the same manufacturer I am confident they will be close.
Setting 1
9600
Setting 2
12,000
Setting 3
16,500
Setting 4
21,500
Setting 5
26,500
Setting 6
29,500
Each setting was tested three times with the “standard” being what is listed, although the variation was less than 150 RPM’s each time.
Comments?
