LR4 Quick and Easy Table Set up

[srcnet]

Check out this topic.

Ryan (creator) put together an easy to make table a couple weeks ago.

~ $200 Full sized Lowrider table, Non-CNC Build

[PXL_20250205_233205080] I went out to see exactly how I would make a table for a 4’x8’ Capable CNC if I did not already have a CNC. Besides just two full sheets of plywood on the floor I think this is the next easiest. I used 0.7"x3.5"x10’ Primed MDF strips, super easy for the torsion box 2"x4"x8’ For the saw horses and cross brace 1/2" OSB sheet for the bottom 1/2"-3/4" Particle board sheet for the waste board. Light gray spray paint just to clean it up a bit. [PXL_20250118_22323995…