Dan and I remixed/created drag knife holders that might hang lower…
https://www.printables.com/model/419594-v1e-lowrider-3-pen-drag-knife-drag-bit-rdz-engrave
https://www.printables.com/model/388240-low-rider-3-pen-drag-knife-mount
2 Likes
I’m guessing the difference is in the height of what it mounts to, as the height specs on Ryan’s part and mine are the same. Below are screen shots showing that. I will remix to get the knife lowered!
Ryan’s:
Mine:
I just posted the revised, lowered version of the drag knife holder.
Both here: Printables
…and here: Printables
I added the following to the CHANGE LOG:
April 17, 2023 - revised the drag knife attachment to lower it, as fellow V1E maker Tom @Tna_331, reported the height of drag knife was too high, needing lowered by at least ½" —this revised version was lowered by 17mm.
Here’s a screen shot of the lowered one:
1 Like
Thank you I will try it out tonight.