KATSU Fräse

Hey,

auf der Suche nach einer Fräse für meinen Lowrider bin ich über die Suche nach “R0700” auf die Katsu 101750 gestoßen. Die ganzen R0700 Clone sind ja alle irgendwie gleich. Massig gute Bewertungen würden mich jetzt schon zum Kauf verleiten.

Die Makita RT0700C ist mehr als doppelt so teuer und die Lowrider wird nur ein Spielzeug, also würde ich gern erstmal mit der Noname Fräse gehen. Gefräst werden soll hauptsächlich Sperrholz Birke und Spanplatten …

Irgendwelche Einwände? Grüße aus dem Norden

1 Like

I have one, and it works fine!

Here in the Netherlands, a real Makita is 160 euro. I bought the Katsu here for 30 pounds plus 13 pounds shipping, so also about 50 euros total.

I have no experience with any other router so I cannot say if it’s better or worse than another one. I only used it for MDF so far, but it works very well for that. I went up to 60 mm/s with 3mm DOC, not bad. And I think the router was not the limiting factor.

Peter, thanks a lot for your feedback. It’s now on my birthday wishlist. :smiley:

I always laugh at “katzu”. It sounds very much like a very common expletive in Italian!