Learned lots on this one. Multiple cuts, multiple choices. Not the most happy with it, but i am just giving it away.
So gold was not a good choice for natural pine! Fonts may look good in inkscape, but then carved may look completely different.
Tried both estlcam v carve and played with f-engrave, stayed with estlcam. I also found out mdf dulled my v bit, but since i painted burn marks didnt matter.
Oh and make sure you raise z if manually moving as pine is not completely flat and may scratch, hence the bottom of established being nearly erased. Been fun but i am ready to move on from this one!