Hello All,
I may have missed it somewhere, but is there a specific post processor for the Jackpot board that needs to be used with the Vectric software? I found the PP for EstlCAM but wasn’t sure if that would work in Vetric.
Can someone please advise?
Any GRBL PP should work. I do not have Vectric so if that doesn’t work just post a list of what is available.
Thank you sir, I will see what I can do.
I did think about taking the one that was written for EstlCAM importing it.
The vetric grbl pp worked for my testing i dont have the board hooked up to my MPCNC right now