tippmar
(Marty T)
February 2, 2025, 9:05pm
1
Finally got the LR4 assembled and ready to start calibrating.
I set the Jackpot to connect to my local WiFi, and controlling it from Safari on my iPhone works without issue.
But when I use either safari or chrome on my iPad, the control buttons don’t seem to be recognized as buttons - tapping them does nothing.
What the heck do I need to change for that to work? The fluidic startup reports v3.9.1 - do I need an update?
CesarH
(cesar)
February 2, 2025, 9:36pm
2
can you share a photo of what your screen is?
does it shows any alarms?
tippmar
(Marty T)
February 3, 2025, 5:25pm
3
Don’t have a photo handy, but it’s the jog / home control buttons at the top of the page. Nothing in that section acts like a button or responds to any kind of tap.
I can send $H via the console and it works fine, so it’s definitely connected to FluidNC.
CesarH
(cesar)
February 4, 2025, 11:19am
4
Marty T:
photo handy, but it’s the jog / home control buttons at the top of the page. Nothing in that section acts like a button or responds to any kind of tap.
I can send $H via the console and it works fine, so it’s definitely connected to FluidNC.
if you dont provide a picture of the screen we are all going to be trowing kicks into the air.
lets try this:
click this and try the jog controls after homing
did you ever get this working? i have had the same problem and never got it working.
If you connect automatically via the captured portal thingy or however it is called it is not going to work. You have to go to Safari and type the address manually.
1 Like
in both Safari and Chrome. I just put the IP address. The Gui loads. I can use the touchpad in all the boxes BUT the control box buttons…
1 Like