Hose Clamps with cord clips

[niget2002 (David Walling)]

I went the aluminum angle route with my Z axis cables. The vac hose is still dangling from the top of the enclosure so I can take it off and clean the spoiler board after a project

New Build in Texas

It doesn’t look like much, but it took me an hour or so to fully rewire the Z axis. I also took the time to cut the spindle’s power cable and run it through a connector. I can now undo two connectors and pull the entire Z assembly off. BTW: make sure you unplug the spindle before cutting the cable… got a nice spark out of that one. [0216201550] [0216201550b] [0216201550a]