Homing not possible because Endstops not trigger

[bms231]

what board do you have? i have an skr 1.2 and there is an issue with the LEDs drawing too much power so you never trigger. i have a thread on it around here somewhere.

Check this thread out…

Problem with x not stopping when homing

Below are photos of how to make a pigtail to solve the pullup problem without soldering to your board or do anything overly complex. Items required: 1.5k resistors HiTec Servo Terminal Kit Crimp Tool Heat Shrink Tube Process in photos: [pigtail1] I make the smallest little white wire possible so it can go into the connector and also be flexible so it can fold over in your case. I then solder the resistor wire (shortened of course) to the white wire. [pigtail2] [pigtail3] [pigtail4…