Hello everyone. When I try to install Guffy’s post processor in fusion I get an Invalid Post Processor error. All the files from git are unzipped into the same directory. I try to load DIYCNC_Marlin20.cps, but I have tried all 3 of them. I’m not sure what I’m doing wrong but I’ve seen a lot of y…

I’m not sure how you are installing or what you mean by loading. Based on this Fusion 360 article , I put the Guffy files here: C:\Users\rober\AppData\Roaming\Autodesk\Fusion 360 CAM\Posts And everything worked. I accessed the PP inside of fusion using the CAM. Note while it doesn’t hurt to put …

Fusion360 Guffy Post Processor

Software / Firmware Fusion360

Flyfisher604 (Don Gamble) February 24, 2021, 2:03am 9

There is an updated post processor with enhancement and bug fixes that can also be installed using the Fusion 360 standard install processor.

1 Like