Fusion 360 PPs for RAMP 1.4 board

Mostly Printed CNC - MPCNC Advice
2

I don’t have firm answers for your questions. A few comments:

  • I’ve been using Fusion 360 for a couple of years for MPCNC milling. I’ve never setup a machine in the way you are doing in your image.
  • The latest version of the Filyfisher604 Fusion 360 Post Processor I’m aware of is V2.1. See this topic.
  • When I first setup a Post Processor in Fusion 360, it was a manual process. Here is the link to that manual process including specific instructions for the Mac.
2 Likes