New build. I recently had to error-line by error-line comment out gcode lines that would not allow my Fusion 360 post processed program run. They included spindle speed or LCD screen in this case. Errors commented out were: ERR: 23 (Gcode command value not an integer) - M code had number but te…

Fusion 360 Post Processing including Gcode not accepted by Jackpot?

staffordj (Stafford) March 11, 2024, 7:53pm 3

If you have not seen it yet, you may want to check this thread:

@Flyfisher604 developed the post processor and has not tested it on the Jackpot. I have, but I don’t use it for spindle control.