Full sheet MC-MPCNC lowrider in Québec

[SupraGuy (Dan)]

I made up a plate to mount the PSU to the Y plate.

Low & Slow. This is gonna be a while

Okay… Now that the distraction from the distraction from the distraction is sorted, time to get back to the project. I was looking at adapting V1’s case for the TFT35 E3… But Ryan beat me to it, so I just printed his. I still needed a mounting solution for my power supply and the SKR Pro 1.2, so I came up with this: [LR2 board Mount] The outer holes are 86.5 by 138mm, sized for the SKR Pro board. The other ones are 80 by 120mm, sized for the power supply that I intend to use with it. (The on…

At 1/4" thick, I can use one for the SKR Pro on one side, and the PSU on the other.