FluidNC - Alarm 3?

Software / Firmware Jackpot Board / FluidNC
1

Hey all,
I have been doing some generic prints that should be straight forward. I keep getting what appears to be random Alarm 3 errors and I cannot figure out why. The MPCNC is not anywhere near and home on X or Y and there appears to be no blockage of any sort. I am using v3.8.3 of FluidNC and Ryan’s V3 configs here. I do see some pre-releases of FluidNC that appear to mention some crashes. Anyone have any advise on a good release to use or if my issues are related or are for another sort of reason.

Thanks!

2

3.7.17 is currently your best release. 3.7.18 and above have issues of various kinds.

Beyond that, you’ll need to show fluidterm log output of your crash to help further.

3.8.0 up to 3.8.3 are known unstable.

There are candidate releases available but i advise waiting a bit more unless you wand to do debugging tests.

4 Likes
3

Sweet thanks!