ESTLCAM Cutting Plane Starts at Z not build surface

[Tokoloshe (Philipp)]

@robertbu

Now on to your problem. It is highly likely your issue is because you do not set a home position relative to your “stock” (paper in this example). Add the following line to the top of your g-code file:

G92 X0 Y0 Z0

This line will establish the router position (tip of the pen) when this line is executed as the home/origin position for the job. Your g-code moves down 1mm to start drawing, so you want your pen tip to be just off the surface of the paper when you start the job.

Robert gives the needed hint in another thread, see above.