End Mill Bits - Canada

Mostly Printed CNC - MPCNC Advice
1

I really tried to figure this out by myself, didn’t want to bug anyone but I’m at a loss. I was going to buy a couple of “1/8” 2 Flute Carbide EndMill" and a couple of " 1/8" Single Flute Carbide Endmill" from the shop here, trying to keep the cost low to avoid getting hit with customs. But when shipping is more then that the cart’s total, it just doesn’t make sense.

I’ve been looking on amazon.ca and my lack of knowledge in this field is annoying. All I want to start doing once I finish my MPCNC is cutting the MP3DP parts. I know I need a 1/8" single or dual flute upcut end mill bit, but the search results are throwing me off.

Can someone please tell me if this is ok?
What about this?

I found this from homedepot.ca, would this be ok as well?

Thanks.

2

I have used the Freud bits and they have worked well. KMS tools also has end mills but the selection is not always the greatest. Have not used the KMS bits too much to rellay provide a good review.

1 Like