Thanks Jonathan. Was going to hold off from sharing details until am happy with the cuts. Incase this helps, am currently using…
But not ideal, the chips are not clearing, but then I didn’t bother to rig up compressed air or cooling other than a Vac without a shroud, or decent suction. Still tinkering, when not doing other things I should be focused on 
Using this 1/8" V bit 60 Degree Engraving Bit, with offset point (like Jeff suggested) for initial carve to get desired depth…
Note, am still learning about edge lit stuff, doesn’t look like deep carves are a good idea anyway?