I made sure that all my axis were square before starting, but I am some how coming out with a part that is slightly askew. [image] Any help will be greatly appreciated

Cuts askew

jeffeb3 (Jeffeb3) October 5, 2021, 1:22am 9

[IMG_20210425_165719] Back in its corner. I added 3/4" aluminum angle. I bought the 1/8" thick ones, but I think it was a waste of money. They were $20 each. Oh well. It rode very smoothly when I didn’t have the belts on. Let’s hope it stays as smooth. I am reworking the hose/wires next. Then I will plug it in.

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled