Yes, profile tool Tip angle is always 180 and Tip offset = the profile Toolpath depth. I’m pretty sure that Chamfer width has no effect when Tip angle = 180, that changing the profile Toolpath depth requires changing the Tip offset (e.g. to cut a partial profile*).
profile max diameter (26.98) / 2 = profile radius (13.49)
pilot (or flat) diameter / 2 = Center offset (4)
profile radius (13.49) - Center offset (4) = profile width (9.49)
Tool tip to top of profile = Tip offset (16.5)
*Which explains why Tip offset is always a tip to top distance for profile bits (something I wondered about in an earlier post) and a negative theoretical to actual tip distance for flat/blunted chamfer/Tip angle tools (the later should, but doesn’t, work with Carve paths).