Jonathjon
(Jonathan Jones)
May 4, 2024, 7:10pm
11
Dreyfus:
IMG_7994960×1280 493 KB
Nice! Not sure I’ve seen one cracked like that before. I bet that bolt was overtightened lol. Don’t worry I’ve split 2 of them down the middle over tightening my spindle mounts LOL
FINALLY getting back on this rebuild. Ended up finding the root of the cause. Aparently I’m tightening the spindle like it has to take a ride to the moon lol. Found a huge crack in my smaller machine and after that I went and looked closer at the full sheet core and sure enough it was cracked in the same place. When @vicious1 says to go easy he means it lol.
[IMG_4314]
[IMG_4315]
With the new core installed on the smaller LR3 now it’s time to mill out the acrylic needed to go behind @DougJos…