Or maybe double check the screws on the pullies. But i liked the way it turned out.
Or maybe in the estcam make the final pass a touch deeper? Im sure there is a setting in there for that.
Or maybe double check the screws on the pullies. But i liked the way it turned out.
Or maybe in the estcam make the final pass a touch deeper? Im sure there is a setting in there for that.
For carves there is no option to change the finishing pass as far as I know.
For 3D carves, the way to do it would be make the final pass thinner, so leave less stock on the roughing pass, or decrease the step over on the finishing for that tool.
Much thanks. But at last it is not a 3d carve. But I did forget that i have a bunch of the tool list setting hidden because I dont use them. Time to look at the good ol’ default settings.
Thanks for the help