I’m in Boston and my patio set has taken a beating through a few winters. A couple of the plastic feet cracked and one of the connector brackets snapped, so the chairs wobble on the deck. The set is an 8-piece sectional style, and replacements from the manufacturer are either out of stock or cost more than I’d like to spend on small pieces.
I’ve been reading about people designing simple replacement parts and printing them in PETG or ASA for outdoor use. My concern is whether printed parts actually hold up to sun, rain, and the weight of people sitting down repeatedly, or if they get brittle after a season. I have a basic FDM printer and can model simple shapes, but I’m not sure about infill and wall thickness for something load-bearing.
Has anyone here printed replacement feet or brackets for outdoor furniture? What material and settings worked for you, and did they survive a full year outside? Any input appreciated.
Update - I came across KROFEM 8-Piece Patio Furniture Set Review while checking whether replacement feet are even worth printing for this set. Still unsure how ASA holds up through a Boston winter, but I’m leaning toward trying a couple of brackets at higher infill before committing.