24V 2 Amp power supply sufficient with Jackpot?

LowRider CNC Advice
1

Hi all,
Commencing my LR2-LR3 upgrade and I will be using the Jackpot board along with my existing 84 oz/in steppers.
I have a 24V power supply but it’s only rated to 2 Amps (48 Watts.)
I see the one on the store is rated to 2.5 amps (60 W). I intend to keep it around stock settings, but wanted to run it by the forums if I’m cutting it too close. I’ll probably order the one from the store eventually, but I’m eager to get things ripping around!

Thanks!

Pic for fun: lr2 boneyard and stepper!

PXL_20231231_072439686
PXL_20231231_0724396861920×1446 325 KB

PXL_20231231_051400174
PXL_20231231_0514001741920×1446 462 KB

2

Ended up just ordering the power supply from the store. Might play around with the “weak” one if I get that far before it arrives!