2.5 X 9 metres

[guzzis3 (Damian)]

@CesarH

I wll give you a cheap tip: you can get 50100 tslot extrusion fairly cheap

Thank you for your thought I can buy it in Brisbane at 6 m enjoying them but it’s expensive and I don’t need that I build the table in 2420x1215x16 then 3x31x6000 mm. Cut one and well it to get 9000mm then: 12pcs 3D Printer Wheels V Slot POM Pulley Wheels Gantry Wheel,Transparent 625zz

@Tokoloshe

Leadscrews are out of the question for that length, I’d use a rack and pinion system.

Where can I get that at a good price ? I can make one but it’s a lot of work.

I’m getting better at writing on your system so thank you for that it just took me a while to figure out how to write him all good

[CesarH (cesar)]

@guzzis3

Where can I get that at a good price ?

Check at makersotre transmission systems, they sell a plastic one that works inside the V-slot. They work, i ran one of my cncs with that for more than 3y

[guzzis3 (Damian)]

Thingiverse is Amazing. I have a 3D printer. I haven’t got it going yet but I do have some white PLA. I can make 400mm and run it to the 9m.