Z Probe Touch Plate

[Olivier]

It’s the feed rate:)
Have a look here:

Lowrider 2 journey

I probably would not raise Z to 200 from 14. Too time consuming and not needed just to remove the probe. G0 is probably the correct code to lift Z (That’s what I use) but I see that you didn’t have a feed rate specified. F500 is pretty slow, and raising 186mm at 500mm/min takes something over 22 seconds, which is quite a long time for setup. I lift mine by about 9mm, which is plenty to remove the probe. I also use a relative move for this. You can optimize a little better with the G92 comman…