Engagement Ring Box:
My buddy asked his fiancé to marry him on top of Grays Peak and I had some left over Maple and Walnut to use so I came up with this thing. It was my first two sided milling for the top part and boy was it a pain in the butt. I think I had about 10 scrapped tops that went to the burn pile from a stupid locating mistake. But I’m very happy with how it came out and I hope they will like it.
Material: Maple, Walnut, Permanent Magnets, Velvet from a cheap Ring box, foam
Finish: Satin shellac
Bits Used:
- 1/8" 2-Flute Endmill
- 1/8" 2-Flute Ball End Mill
- 1/8" 60 Deg V-Bit
Machining Time: 2 total hours for topo / 2 total hours for box
