So close to getting it started up for the first time. I’m not sure how to manage the cables for the X stepper and limit switch (and router power cord eventually). I tried putting them in a plastic wire loom but it flops all over. I almost wish I had a stiff plastic/fiberglass piece to put in there to give it some form. Kind of like the cable management system on the Prusa XL. I tried looking around for a chain system but haven’t found anything yet that works with the V1 Engineering Jackpot case.
I also realized I installed the control board the wrong way with the stepper drivers on the bottom so I’ll have to flip that around and reconnect the wires at some point.
Edit1: Just realized, I could just add the vacuum hose and that would almost perfectly solve the problem. Not sure how I missed that obvious feature.
Edit2: I found this post from Doug. Went ahead and ordered the suggested cable chain and will print the parts in the coming days. Looking to build a low rider - #66 by DougJoseph