Crash85
March 24, 2020, 3:42am
5
Yep, grounding is definitely a must. I ran a plasma cam table almost 20 years ago, and it took us a minute to figure out the emf issues. Gotta shield the machine, as well as ground the wires.
Dui’s solution for safe keeping!
Yay! It’s working guys, it’s finally working! Alleluia!
So, after a lot of hard work, I finally managed to get the plasma cutter to work properly with the MPCNC. It’s been quite a challenge, but now I’m pretty confident the MPCNC will run quite a bit more reliably.
So, what have I done?
-Shielded everything I could shield: all the motor wires are shielded. On the motor side, the motor body is attached to the wire shielding using some breaded copper sleeve. Then on the other side, the motor ca…
1 Like